Information

[sherry]

Hello Ladies- I always get such good answers on this forum!  I have a Cuttlebug, and LOVE it.  I have many of the Cuttlebug & Darice embossing folders.  I also have a Cricut (original) so I haven't purchased a lot of die cuts for the Cuttlebug, but I am really taken by some that Spellbinders puts out.  I ordered the additional C plate, I know I need that.  Slowly learning.  Here's my question-- I found SO many lovely rectangular/oval die cut ones from Spellbinders that I would like to order for my Cuttlebug, but when reading the dimensions of the actual metal pieces, some are bigger than 5" and longer than 7".  Am I correct in thinking that the Cuttlebug can only hand 5x7 inch stuff?  I can't buy anything bigger to run through it?  Please advise on your experiences & knowledge.  Thank you!

[Scrap Bug]

It can take dies up to 6" wide, and you can get an extender plate to take the longer dies.

[killarney_rose]

I just purchased Anna Griffin's Cuttlebug last week so I could emboss.  And I love love the results I am getting!  I'll only use it for embossing since I have had the Qucikutz Revolution since 2007.  Next machine I get will be the WRMK Evolution.  Hopefully sometime next year.  I, too, will be going after the A and B Plates to emboss 12 inch folders. 

Melissa is exactly right!  If you are comparison shopping the price at HSN for the 6x13 plates is $39.95 and one can buy the extra B Plate if your embossing for $19.95.  They also have the replacement plates in the regular size.