ACOT Message Board

Hello ladies! Are you ready to follow along? This will be fast paced and I know many of you will be coming back later to do this class.

Remember to take care of all the pre-class instructions first! You can find them HERE.

I'll just be watching, and doing it later. (Didn't get to do the pre-class stuff)

Have have been wanting to do this for a really long time! This little shelf is soooo cute!!!! i can't wait to see the completed project!

Stacy, you don't have to wait long because here is my completed shelf! Of course the shelves done in other papers will look different but I think this project is so adorable that it would be impossible for it to NOT look great!

Good morning and so glad to be able to follow along and watch!
Yahoo!

Stop it right now! It is even cuter than I imagined!!!!!!! So excited!!

I sure hope Jeanelle can join us; I know she has been very anxious to see this class.

Oh that is soooo cute!
I can't wait to do mine.

letumom wrote:I sure hope Jeanelle can join us; I know she has been very anxious to see this class.

I hope she can join us too! At least she will be able to read the article later if she misses it.

That is why I haven't started mine.
I can't figure out what color to paint it.
I am doing it in BoBunny Abbey Road!

I like to use my ATG gun for everything! You could easily use Mod Podge or another wet adhesive or any strong tape runner. I prefer dry adhesive because it makes less of a mess and I don’t have to wait for it to dry!

You can use several methods to cover the panels with paper. The one I used was to simply put adhesive around the entire edge of the shelf panel, then lay the paper down, and then use a craft knife to cut around it. I very lightly sanded any bloopers or funny edges. You could also trace the panel onto the paper itself, cut it out, and then adhere it. It’s up to you!

Cover the INSIDE of the side panels first and remember to cut out the little tab hole. Also cut the tab hole in the back panel. BUT… when you cover the outsides of the side panel do NOT cut out the holes! The way the shelf fits together makes it so that your paper will cover those tabs.

ScrapGoo wrote: BUT… when you cover the outsides of the side panel do NOT cut out the holes! The way the shelf fits together makes it so that your paper will cover those tabs.

This is so good to know!

My panels looked like these:

(back)



(inside sides)



(outside sides)

Hi gooeypoo, I love this project!!!! Had to stop by and see it. Looks amazing!!!

YAY JESS IS HERE WOOOHOO. I AM SO EXCITED ABOUT YOUR CLASS GIRL!!! I always love your classes. So glad to see you on!

That is darling!!!

And then entire shelf looks like this when assembled:



At a later point you will want to use some good craft or wood glue to permanently glue the shelf together.

It will be much more solid that way!

Thanks Beth, Ally, and Ondrea! I loved this project!

Every photo and step shown here will be on the instructions you post later?