Graphs not expanding correctly

[cactus_jack]

Hello all,

I have cacti-0.8.6c running on a RHEL ES 3.0. I used rpms for all the dependent apps that were needed and configured cacti of source.

The issue I seem to have is my graphs are not expanding as the numbers expand on the data. for instance i have a linux server that is graphing the load average and logged in users, both of these charts will not expand beyond 4. I know for a fact that there are more then 4 users logged into this system on a daily basis. Can anyone tell me what it might be.

Also, I have no patched this install because as I posted earlier it broke my install when all the patches were applied.

Another note I have cacti-0.8.6c on FC3 at home and it is graphing and showing the correct amount of data on the graphs. I built out that cacti install entirely out of RPM's

Thanks all

[cactus_jack]

Ok the expanding of the graphs is working fine after further review BUT i see that the logged in users graph is graphing the same numbers for all my other systems based of the localhost logged in users. Everytime I increase the number of users on my localhost I see the changes on all my logged in users for other systems. Can anyone pls give me any indication of what this might be?

[cactus_jack]

Actually all of my graphs are recording the data for my localhost to all of my other linux systems graphs. HELP pls!!!!

[rony]

That's because that template is for localhost only......

You need to use the Hostmib template or the NET/UCD SNMP template.

[cactus_jack]

dang it ....thank you very much for that pointer....i am a total newbie to cacti