Supplemental Graph Template Data Sources are empty

[meshnetwork]

Hi,
I modified graph template and changed graph template items. Then, i reinstated the template but my graphs is gone and the reason is that my all graph's data sources are empty or mixed in "Supplemental Graph Template Data" area. You can see problem in snapshots below.

cacti_error.JPG (98.13 KiB) Viewed 971 times

When i selected the right data source, it is OK, graph comes back, but i dont want restore each graphs, i have 500+ graphs totally.

How can i restore all graphs and what is the reason of this problem ?

By the way, when i added new graph, graph is just fine. The problem is about existing graphs.

Thanks and regards,

[meshnetwork]

Guys, isn't there anyone who have information about this problem ?

[junaid360]

Hi, I have the same issue, can someone support please, thank you

[TheWitness]

On this old version of Cacti, you simply have to re-assign them. It's such an old version of Cacti. Once you place the right values there, the graphs should start updating again.

Sometimes this happens when you accidentally uncheck the following three checkboxes on your Data Template. Before Cacti 1.x, this was not recoverable without performing manual updates. It's a bit harder to make that mistake on Cacti 1.2.x though.