Cisco snmp-server view

[mregini]

Hy from Italy.

My wish is to limit the snmp community LAB to see only the Gi0/0 interface graph on my Cisco router.
I did many test with "snmp-server view" but I have this strange behavior: I can add the device to CACTI, I can create graphs for Gi0/0 but the graph remains empty.

However if I run the "Realtime Graph Viewer" i can see a the Gi0/0 graph.
What I’m missing?

This is my configuration, probably redundant.

snmp-server view LAB system included
snmp-server view LAB sysUpTime included
snmp-server view LAB ifNumber included
snmp-server view LAB ip.*.1 included
snmp-server view LAB ifEntry.*.1 included
snmp-server view LAB ifIndex.*.1 included
snmp-server view LAB ifDescr.*.1 included
snmp-server view LAB ifType.*.1 included
snmp-server view LAB ifSpeed.*.1 included
snmp-server view LAB ifOperStatus.*.1 included
snmp-server view LAB ifInOctets.*.1 included
snmp-server view LAB ifOutOctets.*.1 included
snmp-server view LAB ifName.*.1 included
snmp-server view LAB ifHCInOctets.*.1 included
snmp-server view LAB ifHCOutOctets.*.1 included
snmp-server view LAB ifAlias.*.1 included


Marco Regini