Mitsubishi 1100a 3phase Netcom2

[tgreaser]

Hello.
I have worked on some data and graph templates for some Mitsubishi 1100a 3phase ups system that have a netcom2 network board.
My first attempt to give back to cacti world.. This was setup to graph the ups to get the following info.

battery_charge
battery_voltage
bypass_amps_leg_a
bypass_amps_leg_b
bypass_amps_leg_c
bypass_freq
bypass_voltage_leg_a
bypass_voltage_leg_b
bypass_voltage_leg_c
input freq
input_voltage_leg_a
input_voltage_leg_b
input_voltage_leg_c
load
output_amps_leg_a
output_amps_leg_b
output_amps_leg_c
output_voltage_leg_a
output_voltage_leg_b
output_voltage_leg_c

[tgreaser]

There is a screw up in the oid on the input volts leg C

bad OID in the data template

use
.1.3.6.1.4.1.13891.101.3.3.1.3.3

[tgreaser]

Updated with more Graph Template Items and oid fix for the input voltage on leg C

[tgreaser]

Not sure why but I never created an template for host import.. Just import the cacti_host_template_mitsubishi-netcom2-3phase.xml and all should be ok.