adding additional info to end of snmpwalk

[brandonb110]

I am trying to graph upstream utilization for our Arris C4 CMTS, when I run the snmpwalk manually all is fine and I get the desired results. In the data query I have:

<docsIfCmtsChannelUtUtilization>
<name>docsIfCmtsChannelUtUtilization</name>
<method>walk</method>
<source>value</source>
<direction>output</direction>
<oid>.1.3.6.1.2.1.10.127.1.3.9.1.3</oid>
</docsIfCmtsChannelUtUtilization>

When I view the Poller Cache it is only using oid: .1.3.6.1.2.1.10.127.1.3.9.1.3.131608

I need .129.1 at the end of the oid so it should be .1.3.6.1.2.1.10.127.1.3.9.1.3.131608.129.1

Is this possible to accomplish? I am very new to Cacti so I apologize if I have not given much needed info.

[BSOD2600]

1) you searched for others which have created arris templates? Most likely dont need to reinvent the wheel...
2) that 129.1 is the index... Look in http://docs.cacti.net/ for guides.

[brandonb110]

I have tried looking on there but still have not found anything I need, I have been searching online for over a week to try and resolve this issue but cannot get anything to work. I am trying to graph the percentage utilization of an upstream port and not just the current bandwidth use number.