How to create graph of a cisco switch

[mahbub82]

I add a cisco switch successfully by giving following info:

Host Template : SNMP enables host
and others..

But when i try to create graph then no interfaces are available.

SO how can i create Switch port graph...

PLZ help me


Thanks and Regard

Mahbub

[gandalf]

Are you running rrdtool 1.0.x?
Reinhard

[mahbub82]

yeah i use rrdtools 1.o.x

I have solved the switch graph problem.

for this i have to install rrdtools 1.2.x version
But another problem is occurred when i create new graph.

RRDTool Says:

ERROR: unknown option '--slope-mode'

I can't understand whats going on ???
Is there any problem with 2 version installed rrdtoos package...

The cacti log show that:
ERROR: Installed RRDTool version does not match configured version.
Please visit the Configuration Settings and select the correct RRDTool Utility Version.

then i change the rrdtools version 1.2.x to 1.0.x and graphs are working.

Now how can i uninstall the 1.2.x version ??


Plz reply me

Mahbub

[vpnnav]

yeah i use rrdtools 1.o.x

I have solved the switch graph problem.

for this i have to install rrdtools 1.2.x version
But another problem is occurred when i create new graph.

RRDTool Says:

ERROR: unknown option '--slope-mode'

I can't understand whats going on ???
Is there any problem with 2 version installed rrdtoos package...

The cacti log show that:
ERROR: Installed RRDTool version does not match configured version.
Please visit the Configuration Settings and select the correct RRDTool Utility Version.

then i change the rrdtools version 1.2.x to 1.0.x and graphs are working.

Now how can i uninstall the 1.2.x version ??


Plz reply me


Mahbub

Do you try to disable SElinux ?

[gandalf]

It's no problem to have two versions of rrdtool installed. But make sure that
- if configuration is set to rrdtool 1.0.x, the /path/to/rrdtool must show the correct path to the binary of rrdtool version 1.0.x
or
- if configuration is set to rrdtool 1.2.x, the /path/to/rrdtool must show the correct path to the binary of rrdtool version 1.2.x

Only in the second case, "--slope-mode" is supported. Cacti will AUTOMATICALLY leave this option off, if it is configured for rrdtool-1.0.x

Reinhard