No pictures could be displayed in Graph->Tree Mode,solved

hbtan · Post by **hbtan** » Wed May 30, 2007 8:26 am

But tracing the link on either item , it will display 4 new graphs. Each of them showing a different timespan, from Daily to Yearly .
It still works. Quite amazing . At the same time "Zoom function" will bring a blank picture too.
What's the problem ?

Post by **rony** » Wed May 30, 2007 8:41 am

Screenshots?

hbtan · Post by **hbtan** » Wed May 30, 2007 9:24 am

rony wrote:Screenshots?

the screenshots for the tree mode

sizulku · Post by **sizulku** » Wed May 30, 2007 10:02 am

I'm having the same problem. This is happen after upgrade rrdtool to version 1.2.23. In apache log, I found an error with "COMMENT" syntax. any help would be great.

hbtan · Post by **hbtan** » Wed May 30, 2007 10:13 am

The problem has been solved .
The default value of the rrd version is rrdtool1.0.x in the "Console->cacti settings "
I have changed it to 1.2.x which is the true value of my environment .

sizulku · Post by **sizulku** » Wed May 30, 2007 10:19 am

it won't work for me. seemed cacti did not support rrdtool version 1.2.23

redrobish · Post by **redrobish** » Thu May 31, 2007 1:36 am

Hi same happens to me...

Can anyone help me?

Post by **gandalf** » Thu May 31, 2007 9:57 am

Please check font file name settings (Settings -> Paths). They must show a font file name, not a font directory name
Reinhard

hbtan · Post by **hbtan** » Fri Jun 01, 2007 9:47 pm

redrobish ,
I have met the same situation when i added my switch as a new device.
At the same time , I found the status of the switch is down in the "Console -> Devices" , though the switch supports the snmp well .
I changed the value in Console->Settings->Poller->"Downed Host Detection " to "Ping and SNMP - Most Recomnded"(the default value is SNMP") , then the status of the device is "up" . The pictures of the switch comes out .

sizulku · Post by **sizulku** » Sat Jun 02, 2007 10:55 am

gandalf wrote:Please check font file name settings (Settings -> Paths). They must show a font file name, not a font directory name
Reinhard

Gandalf,

What is the correct value for font file name settings (Settings -> Paths)? I've an empty coloum for file name settings. Thanks.

Rgds,
Zul

Post by **gandalf** » Sun Jun 03, 2007 5:06 pm

Empty should be fine, so the default font is used. I'm running

/usr/share/fonts/bitstream-vera/Vera.ttf

, but make sure that this file exists before using it
Reinhard

Cacti

No pictures could be displayed in Graph->Tree Mode,solved

No pictures could be displayed in Graph->Tree Mode,solved

Who is online