ZyXEL P-600 series traffic analysis w/Multi-NAT

[Mr.Idle]

Hi! My set-up is fairly simple. I have a Prestige 660HW-61 router, and four computers hooked to it. Through multi-NAT, each computer gets its own public IP address. Actually, there are five public IP addresses assigned to it, the fifth only being used on occasions. Nevertheless, I can't figure out how I can collect the statistics for each public interface.

Has anyone tried or knows something about this?

[dust2k]

you need find out your modem support SNMP or not, if it does, then things are very simple, you can find out an adapter on each RJ45 port then u can tracking their traffic

[Mr.Idle]

Thanks! The router supports SNMP versions 1 and 2c (currently using 2c). By using some of the pre-installed templates I can easily retrieve bandwidth usage for enet0, enet1 and pppoe. That only gives me information for the first public IP address, however. When I click Verbose Query under Associated Data Queries, I can see that it doesn't pick up the other four public IP addresses at all. Well, if it does, it's neatly encrypted.

How would I go about finding the connected adapters? Could you perhaps give me an example of commands or parameters to use? Even how I could do it using snmpwalk from console would prove quite valuable to me.