Device not updating equipment type in Cacti.

[opt8low]

I am having an issue where I have changed a couple of cards in a Cisco7206 and they will not show up in the New Graphs for that device. Just shows the old card type. Going from a ATM/DS3 card to an ethernet card.

Do I have to delete the device and rediscover it? I have looked in the software but I have not found a way to have it see this new card.

I am most likely missing something, as usual. Never really claimed to be that smart.


opt8low

[fmangeant]

Hi

can you try to reload the "SNMP - Interface statistics" data query ?
You just have to hit the green circle.

[opt8low]

fmangeant,

Thanks, I figured it was something simple.

Someday I might become smart.....


Thanks again,


opt8low

[Drew T.]

I'll one up you there. I recently changed from a 7206 VXR NPE-300 to a 7206 with a G1 card. I tried to just update the interfaces which worked and only listed the three GigEth ports on the G1 and refuses to list the Sub-Interfaces. It will list the IP Addresses but does not recognise the standard sub-interfaces.

I've tried this with a standard 'Cisco Router' Template and the more specific '7200 template'. Not having any joy anywhere.

Can anyone shed any light on this? Cheers.

[TheWitness]

Drew, are you using snmpv2 to poll the interfaces? If not, change to v2 and then refresh your interfaces again.

TheWitness