Redhat 8

[bshoe24]

Could someone highlight the extra steps neccessary beyond the basic docs to get 0.6.8a working under Redhat 8. Based on my searching of the board I think I'm having the PHP-SNMP problem.

I've tried gathering Interfaces off my Cisco routers and I'm getting nothing.

This was working before on this same machine on RH 7.3 so, my snmp devices should
be setup fine.

I'm using the php-snmp from the install iso's.

Are there workarounds to get this working on RH8?

Thanks for the help,

Brandon

[bulek]

I believe php-snmp rpm on RH 8 is broken. You have to either compile by yourself or wait for update from RH . You can also try to use external snmp commands instead of PHP's built-in.

- bulek

[Flux]

Yeah, something is broken in RH8 but I managed to get mine working.

Check out these threads:
1) Downgrading snmpd: http://www.raxnet.net/board/viewtopic.p ... highlight=
2) Adding MySQL support for php: http://www.raxnet.net/board/viewtopic.php?t=998

I hope it helps.

Flux

[bshoe24]

Thanks for the suggestions.

I will try to remove the built in stuff then..

Brandon

[necik]

I think this is related to RedHat bug. Look at:
http://bugzilla.redhat.com/bugzilla/sho ... i?id=74761
http://bugzilla.redhat.com/bugzilla/sho ... i?id=78215

They know about this.

[bshoe24]

Thank Necik..

I await there fix then.

Brandon

[bulek]

Experimental corrected RPMs are available here: http://people.redhat.com/jorton/Phoebe-php/

Can anyone test them on RH8 with net-snmp?

- bulek