Traffic Graph Change - No Update

[natrlhy]

I have several network graphs that I have been capturing information on and graphing just fine.

Under Console -> Data Sources -> (Edit) and editing the traffic graph, I have changed the Custom Data; Output Type ID from In/Out Bits to In/Out Bits with Total Bandwidth.

However the graphs do not reflect the change and do not show the Total Out: information on the graph.

How do I update the graphs and still retain the old data or is this possible?

Thanks!

[fmangeant]

Hi

you should also change the graph template (from "Interface - Traffic (bits/sec)" to "Interface - Traffic (bits/sec, Total Bandwidth)").

[natrlhy]

fmangeant,

Thanks! When I went into Console -> Graph Management and looked at the template names they were Interface - Traffic (bits/sec)

I changed the ones I wanted to Interface - Traffic (bits/sec, Total Bandwidth) after the next poll it updated the graph with the current total bandwidth.

Many thanks!

[natrlhy]

After making the above changes the Total Out bytes always stays at 0. The graph is updated but just not this value. Is there something else I need to do? I've tried Rebuilding the Poller Cache in Console -> Utilities but that didn't resolve this.

Thanks!

[natrlhy]

Not sure where I had this issue when I originally posted, but I'm getting this again with a new install...

I had to go into each graph and ensured that each graph was pointing to the correct Inbound Data Source (traffic_in) and Outbound Data Source (traffic_out) source. Each one I had to click save for it to work.