SNMP Error

abhijith · Post by **abhijith** » Fri Dec 22, 2006 2:48 am

Hi,
I am new to cacti.I have installed it in windows.But after adding a device when i click on create it gives SNMP error.
Plz let me know how can i solve it.
Thanx and regards.

abhijit

Post by **gandalf** » Fri Dec 22, 2006 3:13 am

Please refer to fmangeant's sticky SNMP HowTo in the howto section of the forums
Reinhard

abhijith · Post by **abhijith** » Tue Dec 26, 2006 7:28 am

i have installed Cacti.after adding device when i create graph then it gives the following messages.

+ Created graph: test - CPU Usage
+ Created graph: test - Traffic - 127.0.0.1 (MS TCP Loopback)
+ Created graph: test - Traffic - 192.168.100.86 (Intel(R) PRO/10)

but i can't see the graph.Plz let me know how i will see the graph.

BSOD2600 · Post by **BSOD2600** » Tue Dec 26, 2006 11:59 am

Moving to windows.

1) read http://forums.cacti.net/viewtopic.php?t=11747

2) sounds like you didn't configure the snmp agent. read my FAQ (in my guide).

abhijith · Post by **abhijith** » Wed Dec 27, 2006 1:22 am

I have configured SNMP agent.Still it is not coming.

Post by **gandalf** » Wed Dec 27, 2006 7:38 am

Did you set up the SNMP agent on the target host(s)? What about the red SNMP error message? Is it gone? Is the cacti poller running from crontab?
Reinhard

abhijith · Post by **abhijith** » Wed Dec 27, 2006 7:54 am

Yes red SNMP error message has gone.but the graph is not coming.

Post by **gandalf** » Wed Dec 27, 2006 8:07 am

Please make sure the poller is running from crontab. Check "RRDTool Utility Version" (see "Settings"); it must match the result of "rrdtool -v". More help is available from my "NaN Debugging" hwoto, see my signature
Reinhard

SNMP Error

SNMP Error

Who is online