Cisco cannot pull memory info

zak · Post by **zak** » Mon Mar 17, 2003 10:06 pm

Hello all,

I have an 2651xm and was looking to pull memory info but for some reason all the OID's I tried from suggestions do not work. Does anyone know of the correct OID's for a 2651xm. I am a newb with snmp so can you refrain from just pasting cisco's site cuz I have no idea what I'm supposed to be looking for. Any help would be appreciated. I am able to pull Bandwidth traffic and Cpu info, just not memory info.

Thanks,
zak

zak · Post by **zak** » Wed Mar 19, 2003 10:30 pm

Ok, I finally found the OID's but there must be a bug or something. I can get everything except the graphing of router memory info. I have done an snmpwalk and verified that I have the correct OID's. The logs show that I am pulling info but it will not graph and this is only happening on the Cisco memory info. Do I have a setting wrong? I have it set to auto adjust on graphing and the data still does not get graphed. I am using Gauge, snmp data.
Any help would be appreciated.

thanks

bulek · Post by **bulek** » Thu Mar 20, 2003 2:43 am

Hard to say without seeing your config. Can you post "rrdtool create" command line visible at the top of Data Source configuration page?

- bulek

Cacti