"Maximum" Does Not Seem To Be Maximum

Post general support questions here that do not specifically fall into the Linux or Windows categories.

Moderators: Developers, Moderators

Post Reply
jlohiser
Posts: 1
Joined: Fri Dec 27, 2002 4:11 am

"Maximum" Does Not Seem To Be Maximum

Post by jlohiser »

I am graphing traffic data from a Cisco 2924 switch. I am trying to understand the maximum inbound and outbound values on the graphs. The maximum inbound traffic on the daily graph is 434.87kb/s however the weekly graph is only showing a value of 177.98kb/s and the monthly graph is showing 86.78kb/s. Why does the maximum value drop for the different graphs? Since I have just started graphing this switch, should the maximum value not be the same for all three graphs? The only major change besides label changes has been the use of the "Turn Bytes into Bits" CDEF function on each graph.

Thanks,

Jim
Flux
Posts: 39
Joined: Fri Nov 01, 2002 12:37 pm

Post by Flux »

This is what I thought too but after re-reading the rrdtool docs over and over again, I finally understood that the graphs are based upon data that is collected and averaged at different intervals.

For further reading, checkout this site: http://people.ee.ethz.ch/~oetiker/webto ... orial.html

Flux :o
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest