total bandwidth graph

stacyr · Post by **stacyr** » Thu Jun 30, 2005 10:07 am

the graph shows all information except the total bandwidth numbers, is that just the way it is, or do i have to change something

Post by **rony** » Thu Jun 30, 2005 11:11 am

You have to create the graph using the "Total Bandwidth" template.

stacyr · Post by **stacyr** » Thu Jun 30, 2005 11:31 am

i have using the graph template -

Interface - Trafic (bits/sec, Total Bandwidth)

but not always does it show the total bandwidth in/out

Post by **rony** » Thu Jun 30, 2005 11:33 am

Can you post an example graph?

Do the graphs that don't work missing outbound or inbound traffic?

stacyr · Post by **stacyr** » Thu Jun 30, 2005 12:53 pm

here is the graph

Post by **rony** » Thu Jun 30, 2005 1:43 pm

Can you post or email me the rrdfile for this? If you view the graph debug output, it will tell you the path to the file.

Post by **TheWitness** » Thu Jun 30, 2005 2:36 pm

Also, please go into graph management and turn on graph debug. If you don't see the results, I suspect another problem in that the rrdtool fetch command is not getting results back to Cacti for some reason. I have seen this before from systems running IIS. Unfortunately, I don't know the solution.

TheWitness

stacyr · Post by **stacyr** » Thu Jul 21, 2005 1:34 pm

here is the rrd file for one of my graphs that is not showing the total bandwidth.

Post by **TheWitness** » Thu Jul 21, 2005 9:33 pm

stacyr,

1) Are you running in Windows?
2) If so, are you running IIS?
3) If so, are you on 2003 or 2000? Server or Workstation?

TheWitness

stacyr · Post by **stacyr** » Fri Jul 22, 2005 9:41 am

running a unix box

Post by **TheWitness** » Fri Jul 22, 2005 10:48 am

What happens when you run a Graph Debug?

TheWitness

stacyr · Post by **stacyr** » Fri Jul 22, 2005 11:25 am

Turning on the Graph Debug Mode

RRDTool Says ok

don't get any other message

Post by **TheWitness** » Fri Jul 22, 2005 11:34 am

Hmm, what version of Cacti? What version of RRDtool?

Then, you will perform the following:

1) Disable the poller for a few seconds from the UI Settings->Poller
2) Turn Logging to DEBUG
3) View a Single Bandwidth Graph from Graph Management
4) Turn Logging to LOW or where it was before.
5) Re-Enable the Poller
6) Goto the Log file and View
7) Look for the CACTI2RRD .../rrdtool fetch ... line
8) Copy it
9) Open a shell
10) Paste it into the shell
11) Execute it
12) Post the results here.

TheWitness

stacyr · Post by **stacyr** » Fri Jul 22, 2005 1:08 pm

rrdtool 1.2

cacti Version 0.8.6d

ran through steps, looking at the log - assuming i'm supposed to look at the View Cacti Log File all I get is a page cannot be displayed.

Post by **TheWitness** » Fri Jul 22, 2005 1:18 pm

This is certainly not good. If you Cacti is internet facing, I have a few minutes to help you.

TheWitness

total bandwidth graph

total bandwidth graph

rrd file

Who is online