Graphing Errors / Discards

jimmygift · Post by **jimmygift** » Wed May 25, 2005 5:50 pm

Hi

I've been unable to graph errors/discards using the provided Cacti template, I know it can be done. Can someone shed some light on this ?

Thanks very much.

Post by **rony** » Wed May 25, 2005 6:27 pm

My first question and the most important, what device are you trying to graph?

And second, what type of interface is it?

jimmygift · Post by **jimmygift** » Fri May 27, 2005 12:43 pm

I'm trying this on a Cisco Catalyst 6500, I just did a snmpwalk on the LAN switch and the ifOutDiscards, ifInDiscards, ifInErrors and IfOutErrors counters are there.

Thank you.

Post by **rony** » Fri May 27, 2005 1:11 pm

It should be working. You do get the graphs generated, but there is nothing on them?

jimmygift · Post by **jimmygift** » Mon May 30, 2005 6:56 pm

Hi

Finally figured it out. I assigned the right datasources to the corresponding graphs, it works ok.

Thanks a lot.

Graphing Errors / Discards

Graphing Errors / Discards

Who is online