Inbound and Outbound Graph Values Identical

Post general support questions here that do not specifically fall into the Linux or Windows categories.

Moderators: Developers, Moderators

Post Reply
belgarath043
Posts: 7
Joined: Mon Apr 25, 2005 2:38 pm

Inbound and Outbound Graph Values Identical

Post by belgarath043 »

I have been running cacti for a while and noticed my inbound and outbound values are always the same. I am running cacti-0.8.6 and rrdtool-1.1.0.49. I have attached a snapshot of the stats on my Internet edge router. Note the inbound and outbound values are the same. In reality, my Internet traffic on the inbound should easily exceed the outbound. After double checking the phyiscal interface I have confirmed these values are not even close. If any one has any ideas I would appreciate.

thanks in advance.

Craig

************** Data ********
*************** Polling Cache:****************
Data Source: xxxxxxxfrw01 -- External Firewall -- - Traffic - w.x.y.z - Hs5/0
RRD: /var/www/html/cacti-0.8.6/rra/xxxxxfrw01_external_firewall__traffic_in_168.rrd
Action: 0, OID: .1.3.6.1.2.1.2.2.1.10.12 (Host:xxxxxx, Community: abcdefg..)
Attachments
this is a snap shot of my Internet edge device.  Note the inbound and outbound values are the same.
this is a snap shot of my Internet edge device. Note the inbound and outbound values are the same.
graph_image.php.png (5.46 KiB) Viewed 1557 times
ahumado
Posts: 4
Joined: Thu Mar 17, 2005 12:57 am
Contact:

Post by ahumado »

Shot in the dark, but i had a couple show up like that and the Inbound and Outbound sources were both set for the INBOUND source. I don't know how it got that way but when I changed it it stayed and worked fine.
belgarath043
Posts: 7
Joined: Mon Apr 25, 2005 2:38 pm

Inbound and outbound values the same

Post by belgarath043 »

Thanks.. I will check that.
belgarath043
Posts: 7
Joined: Mon Apr 25, 2005 2:38 pm

Inbound and outbound values the same

Post by belgarath043 »

Hey that's it.. I changed the Data Queries for SNMP interface Statistics. I wonder why these are not the defaults? I had to click the check box and change the setting under the data templates. Now my data source is in Octets, I am assuming a octets to bits conversion is happening?

thanks for your help
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests