In Cacti 1.2.26, after aggregation, only the 95th percentile values are calculated for the outbound direction

[TheWitness]

Exactly, between the graph template and the value, it's ambiguous. in + out is not the same as max(in, out). Do you see what I mean?

[TheWitness]

Propose a solution. If you think it should be max(in, out), then I can do that on the back side.

[datutu58888]

Exactly, between the graph template and the value, it's ambiguous. in + out is not the same as max(in, out). Do you see what I mean?

Do you mean that in versions before 1.2.25, the value of 95 is based on the statistical average? And the statistics of 95 in 1.2.26 are based on the maximum value?

[datutu58888]

Propose a solution. If you think it should be max(in, out), then I can do that on the back side.

Can the 95 value statistics part of cacti 1.2.26 about aggregate graphics be changed back to the status of version 1.2.25? After the problem of only counting out and not counting in was fixed, it became the sum of in and out. However, maybe I didn’t understand what you meant. Thank you very much for your efforts!

[datutu58888]

In the previous version, the value of 95 was calculated by counting in and out, and the higher direction was displayed in the graph to calculate the value of 95, instead of the sum of in and out! Thank you so much!