How to Create More Template on One Port

[Chaudiya]

Hello All,

Does anyone know how to create a same template but separate download and upload.
Here is my scenario, I have a switch using port 24 and it was connected to ISP then that port 24 on switch I need to separate the upload and download. So the oulling graph on port 24 should be 3 graphs (Upload, download and all in one)

Please see below i have a old cacti which is can create a 3 templace on 1 port, how to use thos on latest version of cacti?

Add template.png (122.87 KiB) Viewed 470 times

Thnak you for answering this

[macan]

Duplicate graph template (Interface - Traffic (bits/sec)), remove one direction. Repeat it for second direction.
And create new graph

[Chaudiya]

Duplicate graph template (Interface - Traffic (bits/sec)), remove one direction. Repeat it for second direction.
And create new graph

Hello Marocon,

How about this? On the graph it seems it was missing 12 ports it only shows 12 ports it should be 24 ports

Missing Ports.png (179.38 KiB) Viewed 461 times

Missing Ports 2.png (193.83 KiB) Viewed 460 times

ON OLD CACTI version

OLD Virsion.png (99.75 KiB) Viewed 460 times

[macan]

go to management -> Devices -> MTI.SW141 -> on the right side "Re-index device"
After reindex, use link on the right side "*Create Graphs for this Device"

[Osiris]

You can increase the "auto complete rows" too. In Settings Visual. That's what's going on. That drop-down would otherwise be impossible with 2+m data sources.