Run every command every poller run

[chrisptech]

I would have searched to see if this has been asked before so I apologies. For some reason when I go to search, it says I need to wait 84 seconds then loops around when it reaches 0.

I have a bunch of NRPE scripts that I am using to get counters off windows servers (See my previous post about that). At the moment, only a few commands are run per cycle but I would like all the scripts to run every poller cycle. I understand that this would put the box under extreme stress but it is only for testing purposes.

Is this possible? At the moment we are running the poller every minute.

[cigamit]

How often it runs is based upon the Data Profile you have setup for the graph. If you are only collecting data every 5 minutes, its not going to run the command every minute, no matter what your poller is set to run.

[chrisptech]

Ohhhh, right. That makes sense. So if I set my poller to 10 seconds and the data profile to 10 seconds, it should run every time?