cannot add graph in weathermap was working fine

[Howie]

Set the BANDWIDTH correctly for that link.

If you can get 182% of the bandwidth, it's not correct

[anmomin1]

Found ISP is not doing traffic shapping on their side so that's the reason it saw utilization of 180%.

SO there is not option for inbound bandwidth and outbound bandwidht?

Also is there a way to show bandwidth for link that I have under weathermap configuration?


Thanks.

[Howie]

Yes, you can specify inbound and outbound bandwidth with the BANDWIDTH keyword. In the normal 'percent' mode, it does expect 100% to be the maximum. You can either switch to absolute mode (which means you'd need a different scale per bandwidth), or just disable that warning. Check for WMWARN33 in the error message section of the manual.

Show on the map? {link:this:max_bandwidth_in} will show the bandwidth in a label or comment on a link.