Plot specific traffic

[Cesarr]

Good Morning,

I do not know if this issue has already been discussed in the forum,

I have a Cisco router with a WAN interface with 50MB, how do I plot a specific traffic of 15MB?

[netniV]

Define "plot specific traffic" as that does not translate very well.

[Cesarr]

Hi,

I need to generate a graph of a specific (origin and destination) traffic, in this case, one specific client that has shapes to allow the rx and tx to a maximum of 15mbps in the 50mpbs link that i have in this interface.

Thanks for the disposition so far.

Regards,

[netniV]

OK, so what you want there is a standard SNMP Interface Traffic graph, additionally you want to make use of the THold plugin to set a standard Threshold alert at 15mb (though you may want warnings at a lower level for you internally too).

[Cesarr]

Hi, thanks for the help, but it's not exactly what i need.

i need to generate a graph with only the consumed traffic from a specific origin and destination addresses, that flows through the monitored interface.
I have this traffic specified at one list on this equipment, and i'm looking for a way to relate this list on Cacti, so i can end with the graph with informations about this traffic only, without considering any other traffic that also goes through this interface.

[netniV]

To be able to do that, you need to have an SNMP source that would give that information out, do you have that?