Graphics do not display or collect data.

[rancini]

I have added some Huawei equipment (Model AR1220) to CACTI monitoring.
In the "in / out" traffic sampling on Ethernet interfaces I have problems. Just put the device on the traffic
is sampled correctly, after approximately 24h without any apparent reason, the graphs are reset. To resume monitoring, you must remove the device and re-insert it again.
What parameters can I check? Could it be an SNMP talk problem between the Cacti server and my devices?
I use the 0.8.7i version

Available for more info.
I am waiting for your Feedback.

Best regards
rancini.

[paulgevers]

I use the 0.8.7i version

Just so you know, this is such an old version that I doubt you'll get help here.

[rancini]

I've updated the version. I'll keep you up-to-date.

Yours sincerely
rancini

[rancini]

Hello
I've updated to version 0.8.8f and the problem is there.
Going to system utily technical support I note the following error in attachment.

I'm awaiting reply.
Yours sincerely
rancini

[rancini]

Hello
I've updated to version 0.8.8f and the problem is there.
Going to system utily technical support I note the following error in attachment.

I'm awaiting reply.
Yours sincerely
rancini

[paulgevers]

I've updated to version 0.8.8f and the problem is there.
Going to system utily technical support I note the following error in attachment.

Did you already configure the right version? If you already tried, what version of rrdtool do you have on your system.