how to reduce the time that the server shows up a device
it takes too much time in order to see the correct status of a device.
how can i configure thats parameters so i can redice the time that the server validate a host again?
Monitor device satuts
Moderators: Developers, Moderators
-
rony
- Developer/Forum Admin
- Posts: 6022
- Joined: Mon Nov 17, 2003 6:35 pm
- Location: Michigan, USA
- Contact:
Re: Monitor device satuts
If I remember correctly, up checks are run from the poller, so they are probably tied to the timing of the poller.
[size=117][i][b]Tony Roman[/b][/i][/size]
[size=84][i]Experience is what causes a person to make new mistakes instead of old ones.[/i][/size]
[size=84][i]There are only 3 way to complete a project: Good, Fast or Cheap, pick two.[/i][/size]
[size=84][i]With age comes wisdom, what you choose to do with it determines whether or not you are wise.[/i][/size]
[size=84][i]Experience is what causes a person to make new mistakes instead of old ones.[/i][/size]
[size=84][i]There are only 3 way to complete a project: Good, Fast or Cheap, pick two.[/i][/size]
[size=84][i]With age comes wisdom, what you choose to do with it determines whether or not you are wise.[/i][/size]
Re: Monitor device satuts
Console >> Settings >> Device Defaults
- up-down.png (9.38 KiB) Viewed 892 times
Who is online
Users browsing this forum: No registered users and 2 guests