Cacti not show Rights

[keyvanik]

Hi i have cacti before and its ok but i install new cacti yesterday and add a graph to it with Traffic (bits/sec, Total Bandwidth)

For example i have 1.5 Gbps but cacti just show 100Mbps i dont know why and my traffik about 2000 Gb and cacti show it 200Gb i take a picture from cacti and other monitoring for can you know to help me better

cacti.PNG (93.78 KiB) Viewed 1089 times

prtg.PNG (31.28 KiB) Viewed 1089 times

[cigamit]

You created 32 bit graphs instead of the 64 Bit. Go recreate the graphs for the host, but this time select the drop down below the Data Query that says "In / Out Bits (64 Bit Counters)"

[keyvanik]

You created 32 bit graphs instead of the 64 Bit. Go recreate the graphs for the host, but this time select the drop down below the Data Query that says "In / Out Bits (64 Bit Counters)"

i do what you say can you see in picture i have set right? i didnt see any changes from before

1.PNG (81.22 KiB) Viewed 1037 times

2.PNG (93.71 KiB) Viewed 1037 times

[keyvanik]

any body cant help?

[Osiris]

Increase the max values of your Data Sources in the RRDfile. The values are being clipped. In the future, make sure that the device supports ifHighSpeed, and that ifHighSpeed is in the resource XML file that is part of the Data Query.

[keyvanik]

Increase the max values of your Data Sources in the RRDfile. The values are being clipped. In the future, make sure that the device supports ifHighSpeed, and that ifHighSpeed is in the resource XML file that is part of the Data Query.

can you say better or can i access you to check it?

[Osiris]

"rrdtool tune filename -a traffic_in:xxxxxx"