[SOLVED] Graph not populating

[jko5]

I followed the guide and provided information requested.

cacti_technicalsupport.PNG (16.36 KiB) Viewed 1878 times

I see the host is responding to SNMP. The device information and interface information populates. I tried to rebuild the poller cache and wait 10 mins. No luck
SNMP services are started on box.

Please advise!

cacti_cactilog.PNG (49.47 KiB) Viewed 1878 times

[jko5]

Here is a graph example with debug turned on.

cacti_graphdebug.PNG (28.8 KiB) Viewed 1877 times

[jko5]

I figured it out. I changed the Poller Type to "spine" instead of cmd. I then rebuilt the poller cache and waited for 10 mins. Graphs are now populating. I used the windows installer from the cacti forums. Not sure why it defaulted to cmd if it uses spine.

cacti_spine.PNG (7.51 KiB) Viewed 1871 times

Here is an example graph:

cacti_int1.PNG (9.91 KiB) Viewed 1871 times

[BSOD2600]

The cacti.log output all looks good. How long did you wait before switching from cmd.php to spine?

the cmd.php poller is less picky and buggy than Spine, but comes at the cost of being less efficient.

[jko5]

It was almost two hours of back and forth between this new install of v0.8.8a and my existing install of v.0.8.7e trying to figure out what chagned.

Because I couldn't see any errors I was reluctant to change anything. Now I am curious if I switch it back, if it will break again. I will let you know.