Using Flowview with HP-UX servers

[Laura4321]

Good morning,

I´ve been searching for an answer before write a post but I couldn´t find what I was looking for.

I have started using CACTI 2 weeks ago, so I´m not very familiar with it and all of its plugins.

I´ve been working with CACTI and Weathermap making some maps of my network. Now, I have installed a new plugin, FLOWVIEW, because I would like to know the amount of traffic of every IP in eth0 interface (for example). I´m monitoring some HP-UX server, they have SNMP protocol active to work with CACTI and I would like to know if I need to activate also Netflow (I´m not sure if it is possible because it is for CISCO switches) or if there is another solution to use Flowview with the information I´m getting from the devices.

Thanks in advance.

Regards.

[masoncharest]

Yes, you need to activate the Netflow to work with Cacti and it is absolutely possible for Cisco switches. Good luck!

http://www.cmserversdirect.com/639829-005.html