Hello
I am using cacti for some time now and decided to add the Mactrack plugin to it. Unfortunately I have a trouble. The Mactrack doesn't seem to work. Cacti Log states that:
MACTRACK: Poller[0] WARNING: SITE: M(cut), IP: 192.168.1.(cut), TYPE: ProCurve J9022A Switch 2810-48G, revisio, ERROR: Device Type Not Found in Device Type Table.
The same situation is with all switches I added. Non seem to work. What am I doing wrong? I'm total newbie in Mactrack. I'm running Cacti 8.8a + Mactrack 2.9-1.
Mactrack newbie problem
Moderators: Developers, Moderators
Mactrack newbie problem
- Attachments
-
- And type
- hp-type.png (94.22 KiB) Viewed 2952 times
-
- Typical device
- HP-device.png (110.97 KiB) Viewed 2952 times
-
- Device list
- Devices2.png (29.83 KiB) Viewed 2952 times
-
- Site list
- sites2.png (15.6 KiB) Viewed 2953 times
-
asterixlinux
- Posts: 19
- Joined: Wed Jul 13, 2011 6:41 am
Re: Mactrack newbie problem
Hi,
this is my configuration with HP ProCurve j9020a Switch 2510-48 with ObjectID: .1.3.6.1.4.1.11.2.3.7.11.62
Work fine with Mactrack --> Macaddress
this is my configuration with HP ProCurve j9020a Switch 2510-48 with ObjectID: .1.3.6.1.4.1.11.2.3.7.11.62
Work fine with Mactrack --> Macaddress
- Attachments
-
- HP_Procurve_2510_49_j9020a .png (120.65 KiB) Viewed 2841 times
Re: Mactrack newbie problem
Big thanks!!!
I copied your config to my HP switch and it works! In the meantime I managed to get all other switches on my network to work except Cisco switches (and HP till now). Well Cisco switches work but don't show any active MACs
I will try to handle it from here. Again thanks!
I copied your config to my HP switch and it works! In the meantime I managed to get all other switches on my network to work except Cisco switches (and HP till now). Well Cisco switches work but don't show any active MACs
I will try to handle it from here. Again thanks!Who is online
Users browsing this forum: No registered users and 0 guests