Good morning,
I´ve been searching for an answer before write a post but I couldn´t find what I was looking for.
I have started using CACTI 2 weeks ago, so I´m not very familiar with it and all of its plugins.
I´ve been working with CACTI and Weathermap making some maps of my network. Now, I have installed a new plugin, FLOWVIEW, because I would like to know the amount of traffic of every IP in eth0 interface (for example). I´m monitoring some HP-UX server, they have SNMP protocol active to work with CACTI and I would like to know if I need to activate also Netflow (I´m not sure if it is possible because it is for CISCO switches) or if there is another solution to use Flowview with the information I´m getting from the devices.
Thanks in advance.
Regards.
Using Flowview with HP-UX servers
Moderators: Developers, Moderators
-
- Posts: 3
- Joined: Fri Jun 21, 2013 5:29 am
Re: Using Flowview with HP-UX servers
Yes, you need to activate the Netflow to work with Cacti and it is absolutely possible for Cisco switches. Good luck!
http://www.cmserversdirect.com/639829-005.html
http://www.cmserversdirect.com/639829-005.html
Who is online
Users browsing this forum: No registered users and 1 guest