Cisco 2950 still CPU usage

[Joris]

Hi,

I'm new in the Cacti world and it works fine for bandwidth but when I try to monitor Cisco 2950 CPU usage it stays fixed at 15%.

Could anybody help me?

Thanks in advance.

[Linzer]

I don't have any 2950's so I'm not sure if this will work (but it does with other Cisco switches):

What does the switch show if you issue a "show proc CPU" from the enable mode? The Top line should have CPU utilization for five seconds, 1 minute and 5 minutes. If they always show 15% you have your answer...