Unable to set Aggregate correctly (HELP)

[tbaror]

Hello All,
I am using CACTI Version 0.8.7g installed on win2k3 along with Aggregate 0.75 ver.
I have a 48 port switch that i would like to Aggregate 47 port without up-link to get the switch load but when i am doing aggregate using AREA/STACK i get only the first Interface chosen as graph , during the cration i get message that all other resources will be removed from graph.
following attached image of all steps i took to create Aggregate .
Please advice
Thanks

[tbaror]

anyone?

[gandalf]

How did you get to "part 4", please?
R.

[tbaror]

How did you get to "part 4", please?
R.

Hi,

Right after part 3 if i don't associate it to graph type and device nothing happen so if associate it to corresponding device and graph i get following.

Thanks

[gandalf]

That should not be the case.
Many people do not now how to find the aggregate, as it is not associated to a host nor a graph template.
This will change with upcoming AGGREGATE 1.0
Until then, please find the graph when searching for template=NONE
It is NOT recommended to associate the aggregate to a host and/or template (the first one is not dangerous but the second is)
R.