Riverbed Steelhead Appliance - statistics

[Tibo]

I performed a lot of checks and it appears that I have a problem on the CPU but also on the connections graphs (and not on interface polling in fact) but I didn't figure out why...

Might it be an issue due to my polling settings (configured at 1 min)?

[Vertigo]

I don't know why, but when I imported the templates the data sources for "missTotal" were set to type GAUGE when they should be COUNTER.

FYI, YMMV, etc...

I found the same issue when using the aggregate bandwidth template just above...

[rmcdonald]

I have the same issue as Tibo any fix for this?

[rmcdonald]

I am experiencing issues with snmp timeouts and poller processes over running. once I disable the steelheads. Cacti is happy again. very strange. started a few weeks ago.

[morgentau]

Im just applied all the templates and they all work fine... Great and nice to have

Riverbed Steelhead, 2050H

[blugger]

Hi together,

I am looking for a new template to get the statistics from Riverbed appliances running RIOS 8.x code.

In the past I used the templates described here:

http://forums.cacti.net/about19610.html

These templates do not work with the new RIOS software version. It would be great if somebody could help out because I am not so experienced with creating CACTI templates.

Hope somebody can help out - many thanks in advance!

Best regards,
Benjamin

[IMHLAR]

I realize this is a very old thread, but I thought others might find this helpful. I'm running RiOS 8.5 and was able to get these templates to work. The key was to make sure the rbt-mib.txt file was copied to the mib directory (typically /usr/share/snmp/mibs).