Thold current value empty, thold never trigger.

[joseph817]

I settup thold to monitor Cisco router interface inbound traffic. In the thold status tab, the "current" value collumn is empty, and thold never trigger. But when I go into the threshold setting detail, I can see the current value.

Hope you can help me. Thanks in advance.

Joseph

[KyRoo]

I have exactly the same issue.
Did you ever found the solution?

Thanks

[TheWitness]

Do you have error's in your Cacti Log?

What version of THold, what version of Cacti?

What happens when you run:

Code: Select all

php -q poller.php --force

From the command line?

TheWitness

[epsmed]

I have similar problem.
I have current value
ID Type** High Low Current Enabled
4 High/Low 160000 1 3015947.2 Enabled

and if i edit the threshold i see
Data Source Item [traffic_in] - Current value: [2619481.7866]

i use 0.42 thold plugin, 0.8.7g cacti
spine 0.8.7g


C:\Inetpub\wwwroot\cacti>php -q poller.php --force
09/22/2010 03:33:59 PM - SYSTEM STATS: Time:0.6812 Method:spine Processes:1 Threads:40 Hosts:6 HostsPerProcess:6 DataSources:51 RRDsProcessed:28

No errors in Log file.

[TheWitness]

You need to PM cigamit imho.

[britcher]

Did you ever find a solution for this?

It has just started happening on my install of Cacti/Thold after updating CentOS. I was running 0.8.7e with Thold 0.4.1. I have since upgraded to 0.8.7g with Thold 0.4.2 but this hasn't resolved the issue.

After testing I have noticed that it only occurs when using 'ALL_DATA_SOURCES_NODUPS' in a CDEF. I 'think' I remember there being an issue with using 'ALL_DATA_SOURCES_NODUPS' previously but this was with a 0.3.x version?

Thanks

[uhtred]

@joseph817 & KyRoo
i cannot reproduce this failure. everything is working fine.

After testing I have noticed that it only occurs when using 'ALL_DATA_SOURCES_NODUPS' in a CDEF.

for what for a graph do u use this?

[britcher]

I was using it on a traffic graph to total the incoming and outgoing traffic, then thresholding on this value.

I am using 'ALL_DATA_SOURCES_NODUPS' elsewhere with Cacti and this is working fine.

Thanks

[uhtred]

ok, ok, i use it for cpu values, too.
but i didn't know, that its possible to put this in a Datasource.