Migrate db from 0.8.7b to 0.8.7e

[BSOD2600]

That whole process sounds correct.

There was only db changes from 0.8.7b to 0.8.7c (you can check this by looking in the /cacti/install/ folder at the various 0_8_7b_to_0_8_7c.php files).

1) Did you double-check all the Settings -> paths?
2) Technical support page show any issues?
3) What happens when you manually run: php poller.php from the command prompt with admin rights?

[smlick]

Thank's, in this case (your installer with IIS install and db import from previous 0.8.7.b) seems that is only a problem about invoking poller.php I'll try to fix.
I didn't understand why the db only adapt from 0.8.7b to 0.8.7c and not to 0.8.7e (your installer is with cacti 0.8.7e).

Regards
Alessio

That whole process sounds correct.

There was only db changes from 0.8.7b to 0.8.7c (you can check this by looking in the /cacti/install/ folder at the various 0_8_7b_to_0_8_7c.php files).

1) Did you double-check all the Settings -> paths?
2) Technical support page show any issues?
3) What happens when you manually run: php poller.php from the command prompt with admin rights?