Gs724 T problems

iggi · Post by **iggi** » Wed Oct 29, 2008 8:12 am

I did get it to work by having it respond from snmp v2c and then selecting a non 64 bit graph. However, I did a factory reset and now I don't have such luck.

Breiti · Post by **Breiti** » Wed Oct 29, 2008 9:40 am

so you get the right value for the traffic the ports do ?
can you please give me a short instruction how to setup the switch in cacti ?

regards Stefan

iggi wrote:I did get it to work by having it respond from snmp v2c and then selecting a non 64 bit graph. However, I did a factory reset and now I don't have such luck.

iggi · Post by **iggi** » Wed Oct 29, 2008 7:56 pm

I simply created the device and selected snmp version 2 and then created a non 64bit counter graph from the port. But, once I preformed a factory reset on the switch I was not able to duplicate any sort of graphs.

mhakali · Post by **mhakali** » Thu Oct 30, 2008 2:16 am

I am having the same problem which you guys are.

Remedy would be cool

iggi · Post by **iggi** » Sat Nov 22, 2008 1:51 am

Try the fix I did for my new linksys switch.

http://forums.cacti.net/viewtopic.php?t ... highlight=

Basically edit the data source so it does not have the equals in the ifname, re run php -q cmd.php (device id) (graph id) and see if that works. I think the equals showed up on my netgear as well but cannot confirm.

Cacti

Gs724 T problems

Who is online