Allied telesyn ar 250 e problem

[Daniele]

Hi all,
I have router allied telesyn ar 250 e, i have configurated snmp service with console, and conifigurated policy nat 1 to 1 for port snmp on private interface (lan), and the my cacti serve access in this router on pulic interface(adsl).

Don't work.

Nothing resposnse snmp.

idea?

Thanks
D

[Daniele]

i have solved,
set, vesion snmp 1 and work only community name public!(bug)

but not work graph....

[gandalf]

Please post results of
"snmpwalk -c ... -v 1 <target> interface"
and
"snmpwalk -c ... -v 2c <target> interface"

Reinhard

[Daniele]

i have tried, but not work

cmd
snmpwalk -c community -v 1 ip address interface
not work
but work correctly:
snmpwalk -c community -v 1 ip address .

[gandalf]

The latter will only output basic system information. For me, it's quite sure that your snmp setup of the target device is not correct or you're using the wrong community string. Please see 1st link of my sig for some basic snmp stuff
Reinhard

[Daniele]

hi gandalf
this is output with snmpwalk -v 1 -c community ip address

[gandalf]

Looks fine. And what does it gve when using "-v 2c" instead of "-v 1"?
Reinhard

[Daniele]

not work
support only v1

[gandalf]

Ok. So you'll have to set SNMP V1 on the host edit screen. Did you do so and what happens, then?
Reinhard

[Daniele]

Connected correctly,status devis change in up.

but in graph cpu ..is blank, and interface graph error, and list interface in "Create Graphs for this Host " is correctly but not create graph correctly.


I have contact allied telesyn , and suggest upgrades firmware with their software, not online.

i waiting news and post in this thread

thanks daniele