I have some cisco Switches and Routes,e.g.:cisco 3560,cisco 3825 and cisco 3845.When i added these devices in to the Catci,Cacti says "snmp error".
I don't know what problems. No templates or config problems? Who can help me?
Thank you so much.
[SOLVED] Looking for cisco 35** and 38** series templates
Moderators: Developers, Moderators
[SOLVED] Looking for cisco 35** and 38** series templates
- Attachments
-
- cisco 3560
- 20080122141026214.png (38.03 KiB) Viewed 2597 times
Last edited by toseeme on Sun Jan 27, 2008 10:30 pm, edited 2 times in total.
- Howie
- Cacti Guru User
- Posts: 5508
- Joined: Thu Sep 16, 2004 5:53 am
- Location: United Kingdom
- Contact:
The host templates are only really a shortcut to save you adding a base set of graphs manually each time. If you can't get SNMP access to your device, then it's not the lack of a template.
Did you enable SNMP on the device?
Is there any firewall between your Cacti install and the device?
On the Ciscos, do you have an ACL defined for SNMP access, and if you do is the Cacti server in it?
You should have something like:
Did you enable SNMP on the device?
Is there any firewall between your Cacti install and the device?
On the Ciscos, do you have an ACL defined for SNMP access, and if you do is the Cacti server in it?
You should have something like:
Code: Select all
! define ACL 6 to limit access to SNMP to only the Cacti server
access-list 6 permit 172.16.4.5
access-list 6 deny any
access-list 6 remark snmp-ro
! define a read-only community (RO) accessible only from ACL 6
snmp-server community ddfsfnnene RO 6
Weathermap 0.98a is out! & QuickTree 1.0. Superlinks is over there now (and built-in to Cacti 1.x).
Some Other Cacti tweaks, including strip-graphs, icons and snmp/netflow stuff.
(Let me know if you have UK DevOps or Network Ops opportunities, too!)
Some Other Cacti tweaks, including strip-graphs, icons and snmp/netflow stuff.
(Let me know if you have UK DevOps or Network Ops opportunities, too!)
thanks for your attention.mcutting wrote:Without sounding a bit dumb (and possibly condescending), did you enable SNMP access on this particular interface ?
I have this problem yet.Could you tell me how to check it step by step?
if you have some Doc.,could you sent it to me ?
I'm reading the Cacti's Doc.
Who is online
Users browsing this forum: No registered users and 0 guests