HP Proliant temperature Graphs

[dmace]

These are temperature graphs for the HP Proliant Series.

[apperrault]

DMace,
These look like they could be nice, but when i add them, nothing shows up. When i go into Graph Debug mode i get the following information.

Code: Select all

   	 RRDTool Command:

E:/rrdtool/rrdtool.exe graph - \
--imgformat=PNG \
--start=-86400 \
--end=-300 \
--title="EV-Ops2 - CPU 2 Temperature Proliant" \
--base=1000 \
--height=120 \
--width=500 \
--alt-autoscale-max \
--lower-limit=0 \
--vertical-label="Celsius" \
--slope-mode \
AREA:#FF0000:"Temperature in Degrees Celsius"  \
GPRINT::LAST:"Current\:%8.2lf %s"  \
GPRINT::AVERAGE:"Average\:%8.2lf %s"  \
GPRINT::MAX:"Maximum\:%8.2lf %s\n" 

RRDTool Says:

ERROR: parameter '#FF0000' does not represent a number in line AREA:#FF0000:Temperature in Degrees Celsius

Any thoughts? this is happening on all 4 of the graphs.

aaron

I was just looking at the Graph templates a little more, and i notice that they are not associated with any data sources. Could this be the problem? I don't see the associated SNMP query to obtain the data that it is trying to gather.

app