Hi,
I've installed thold and all seems ok..
I'd like to enable and test on a few network device interfaces,
with varying link speeds...
what would I enter for high threshold value?
a percentage ?
Or would I have to manually calculate the value for each given link?
ie 95% of a 45Mbps link = etcetetc, 95% of a T1 link =... .
I'm assuming I can just use 0 for the low threshold, since I'd always be getting positive values...
pls respond,thx
1st time using plugin...what to fill in for high threshold?
Moderators: Developers, Moderators
-
- Cacti User
- Posts: 89
- Joined: Fri May 25, 2007 1:18 pm
Who is online
Users browsing this forum: No registered users and 3 guests